top of page

NVIDIA Platforms

Public·8 members

Link for BOXER-8253AI BSP, image and flasher

Could you please provide me BOXER-8253AI BSP, image and flasher? I will need to run JP 5.1.2.


Best regards,

113 Views
Neptune Liu
Neptune Liu
20 nov 2025

Hi Sir,


We do not have the JP5.1.2 version for the BOXER-8253.

However, we do have the JP5.1.3 version for the BOXER-8253.


If needed, please provide your email address and I will send you the download link.


Thank you.


Best Regards,

Neptune Liu

Vinicius César
Vinicius César

Is Jetpack 6.x available?

Hello. Is Jetpack version 6 available for BOXER-8653AI (Orin NX)?


Best regards


119 Views
Neptune Liu
Neptune Liu
07 abr 2025

Hi Sir,


Sorry, I cannot provide a link to the download on this forum, so please contact the window where you purchased it. I will provide you with a download link via email.


Best Regards,

Neptune Liu

Link for BOXER-8653AI BSP, image and flasher

Please, I need the link for the BSP , image and flasher for BOXER-8653AI, can any moderator provide me it? The manual says to download the image but I couldn't find the resource on the product page.

157 Views

Thanks! Will do that

石井 孝佳
石井 孝佳

Can not enter recovery mode BOXER8221-AI-B3-1111

Hi,

I'm using BOXER8221-AI-B3-1111, and I couldn't enter the "Recovery mode".


I read the manual and it says following. I tried many times of this but I can not enter the mode at all.


I have got the OS image from a distoributor and ectract it on the host PC. Then I connect USB cable the PC to BOXER flush usb port.


Case A: the same as the manual

BOXSER Power plug is off. Then connect the power plug, PWR LED on, then push the recovery button 2 second.


91 Views
Neptune Liu
Neptune Liu
01 jul 2024

Hi 石井 孝佳 san,


Due to the 8221 is AT mode, so it will be power on immediately when the power input.

Therefore, to enter recovery mode, you must press and hold the Recovery button (Red Circle) for 5~10 seconds before the power is turned on and then release it.

ree

After that, you can use "lsusb" to check if there is NVIDIA in the HOST PC, if there is, it means it has entered the Recovery mode.


Note, to enter Recovery mode, you must use Mirco USB cable to connect "OS FLASH" (Yellow) to HOST PC.


Best Regards,

Neptune Liu

Members

Copyright ©AAEON 2025. All Rights Reserved.

bottom of page