Link for BOXER-8253AI BSP, image and flasher
Could you please provide me BOXER-8253AI BSP, image and flasher? I will need to run JP 5.1.2.
Best regards,

Could you please provide me BOXER-8253AI BSP, image and flasher? I will need to run JP 5.1.2.
Best regards,
Hello. Is Jetpack version 6 available for BOXER-8653AI (Orin NX)?
Best regards
Hi Sir,
Sorry, I cannot provide a link to the download on this forum, so please contact the window where you purchased it. I will provide you with a download link via email.
Best Regards,
Neptune Liu
Please, I need the link for the BSP , image and flasher for BOXER-8653AI, can any moderator provide me it? The manual says to download the image but I couldn't find the resource on the product page.
Hi,
I'm using BOXER8221-AI-B3-1111, and I couldn't enter the "Recovery mode".
I read the manual and it says following. I tried many times of this but I can not enter the mode at all.
I have got the OS image from a distoributor and ectract it on the host PC. Then I connect USB cable the PC to BOXER flush usb port.
Case A: the same as the manual
BOXSER Power plug is off. Then connect the power plug, PWR LED on, then push the recovery button 2 second.
Hi 石井 孝佳 san,
Due to the 8221 is AT mode, so it will be power on immediately when the power input.
Therefore, to enter recovery mode, you must press and hold the Recovery button (Red Circle) for 5~10 seconds before the power is turned on and then release it.
After that, you can use "lsusb" to check if there is NVIDIA in the HOST PC, if there is, it means it has entered the Recovery mode.
Note, to enter Recovery mode, you must use Mirco USB cable to connect "OS FLASH" (Yellow) to HOST PC.
Best Regards,
Neptune Liu
Hi Sir,
We do not have the JP5.1.2 version for the BOXER-8253.
However, we do have the JP5.1.3 version for the BOXER-8253.
If needed, please provide your email address and I will send you the download link.
Thank you.
Best Regards,
Neptune Liu